ceramic turning inserts for cast iron and steel CNGA, DNGN series ceramic turning inserts, DNGX/SNGA ceramic INSERTS
Grade introduction for ceramic inserts for steel:
CN1000
With Si3N4 substrate, it has excellent capacity against cutting edge breakage and thermal vibration, suitable for
finishing and semi-finishing of grey cast iron. It also has great performance on heavyload intermittent cutting of cast
surface materials.
CN2000
With Si3N4 substrate, it has good wear resistance and toughness. It is suitable for not only intermittent and
continuous machining of hardened steel and grey cast iron, but also machining of die steel and other high hardness
materials.
CA1000
With Si3N4 substrate, it combines high wear resistance and good toughness, suitable for not only intermittent and
continuous turning of hardened steel and grey cast iron, but also machining of die steel and other high-hardness
materials.
Physical properties :
Grade | Density(g/m³) | HardnessHv(GPa) | Bending strength(MPa) | Fracture toughness |
CA1000 | 4.2 | 19 | ≥700 | 4.5 |
CN1000 | 3.25 | 16 | ≥900 | 7.5 |
CN2000 | 3.25 | 16 | ≥900 |
8
|
Shenzhen Lys Technology Co., Ltd
Company address: 20th floor, Saigeyuan building C, Huaqiang south road, Futian district, Shenzhen China
Factory address: No. 57 Jinshan industrial park, Hetang district, Zhuzhou City, Hunan province China
Tel: 0086-731-22397993 Fax: 0086-731-22623865
E-mail: peter@lystechnology.com linda@lystechnology.com
Factory address: No. 57 Jinshan industrial park, Hetang district, Zhuzhou City, Hunan province China
Tel: 0086-731-22397993 Fax: 0086-731-22623865
E-mail: peter@lystechnology.com linda@lystechnology.com
Website: www.lystechnology.com www.lyscarbide.com http://lystechnology.en.gasgoo.com
No comments:
Post a Comment